| 1. | The torques are recorded with a torque sensor
采用扭矩传感器记录扭矩。 |
| 2. | The adaptor of rotary torque sensor is subject to damage
转盘所扭矩传感器接头容易被破坏。 |
| 3. | The implementations of a stewart platform based force - torque sensor in wind tunnel balance
平台的六维力传感器在风洞天平中应用 |
| 4. | There is a nonlinear dynamic problem in the response of multi - dimension force / torque sensors
多维力/力矩传感器的响应中存在动态非线性问题。 |
| 5. | The torque sensor is used to measure the load . the step motor and ball skew are used to drive the headstock
使用扭矩转速传感器来测量转速和载荷，并通过磁粉加载器来控制载荷。 |
| 6. | The successful design of the miniature fingertip force / torque sensor is the basis of the research on multisensory dexterous robot hand
微型指尖力力矩传感器的成功研制为具有感知功能的机器人灵巧手的研究奠定了基础。 |
| 7. | At last the calibration rule of the steward platform with 6 - dof force / torque sensor is offered . the reasons of errors are also analyzed
最后分析了六维力传感器的静态标定原理，并对可能产生误差的原因进行了理论分析。 |
| 8. | After that , the thesis studies and designs the voltage stabilized source , amplifying circuit , single - chip - computer hardware and its software of the torque sensor
研究设计了智能扭矩扳手检定仪的稳压电源、放大电路、单片机系统硬件电路和测量软件。 |
| 9. | Based on big central hole design method , a space manipulator modular joint is developed , which includes many sensors , such as position sensor , torque sensor and temperature sensor
摘要采用大中心孔设计方法成功地研制了高集成度空间机械臂模块化关节。 |
| 10. | Otherwise , some problems of the dynamic calibration of multi - dimension force / torque sensors are studied , and the author of this thesis also gives out his own point of view
另外，本文还分析了多维力/力矩传感器的动态标定实验中的若干问题，提出了自己的看法。 |
